Removal and Replacement Procedures
HP ProLiant DL320 Generation 3 Server Maintenance and Service Guide
2-15
IMPORTANT:
Ensure that the hard drives are installed with the data and power connectors along the
bottom of the tray, facing away from the front vent holes..
To replace the SCSI hard drive, reverse steps 1 through 8.
PCI Riser Board Assembly
To remove the PCI riser board assembly:
1.
Power down the server. See “Powering Down the Server” in this chapter.
2.
Remove the access panel. See “Access Panel” in this chapter.
3.
Disconnect any cables connecting an existing expansion board to the system board.
4.
Unscrew the 2 thumbscrews on rear of chassis (1).
5.
Lift and remove the PCI riser board from the server chassis (2).
Figure 2-11: Removing the PCI riser board
CAUTION:
When removing the PCI riser board assembly, be careful to avoid damaging to
the system cables.
CAUTION:
Be careful to remove the large PCI expansion board, if it is present in the
assembly, since it is guided and supported with a bracket at its end.
When replacing an expansion board, refer to “Expansion Board” following this procedure.
