HP ProLiant DL20 Gen10 Plus, Maintenance And Service Manual

Page: 87 / 246

Removing and replacing the optical drive from the LFF chassis Removing and replacing the optical drive from the LFF chassis
CAUTION: CAUTION:
A discharge of static electricity from a finger or other conductor might damage system boards or other static-sensitive
devices. To prevent damage, observe antistatic precautions.
CAUTION: CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays are populated
with either a component or a blank.
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have a T-10 Torx screwdriver available.
Procedure Procedure
1. If installed, remove the front bezel .
2. Power down the server.
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. Disconnect all peripheral cables from the server.
5. Remove the server from the rack .
6. Place the server on a flat, level work surface.
7. Remove the access panel.
8. Disconnect the SATA-power Y-cable from the optical drive .
9. Remove the optical drive from the bay.
Retain the screw for future use.
To replace the component, reverse the removal procedure.
Removing and replacing the optical drive from the LFF chassis 87