HP ProLiant DL160se - G6 Server, Maintenance And Service Manual, Page: 48 / 119

Removal and replacement procedures 48
To install a non-hot-plug hard drive disk into the carrier:
1.
Put the non-hot-plug hard drive disk into the carrier.
2.
Fasten the HDD to the carrier using the screws (two on each side).
Figure 20
Installing the Non-hot-plug Hard Drive Disk into the Carrier
To install a non-hot-plug hard drive into the server:
1.
Remove the hard drive blank from the front of the system if installed.
2.
Push the hard drive assembly into the drive bay until it stops.
Figure 21
Installing the Non-hot-plug Hard Drive Assembly