Removal and Replacement Procedures
2-24
HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide
3.
Remove the thumbscrews on the back of the chassis to release the power connector (1).
NOTE:
The power connector will not push completely into the chassis until the DC filter module is
removed. It may be necessary to push in the power connector while removing the DC filter module.
4.
Release the latches (2) and lift the DC filter module away from the system board (3)
while pushing the power connector into the chassis (4).
Figure 2-22: Removing the DC filter module
To replace the component, reverse the removal procedure.
Power Button/LED Board
To remove the power button/LED board:
1.
Power down the server blade and remove it from the server blade enclosure. Refer to
“Server Blade Preparation” in this chapter.
2.
Remove the access panel. Refer to “Access Panel” in this chapter.
3.
Remove any hot-plug SCSI hard drives or hard drive blanks:
—
If any hard drive blanks are installed, refer to “Hard Drive Blanks” in this chapter.
—
If any hot-plug SCSI hard drives are installed, refer to “Hot-Plug SCSI Hard Drives”
in this chapter.
