Removal and Replacement Procedures
HP ProLiant BL20p Generation 3 Server Blade Maintenance and Service Guide
2-19
3.
Open the retaining latches (1).
4.
Lift the FC adapter away from the system board (2).
Figure 2-17: Removing the FC adapter
To replace the component, reverse the removal procedure.
Standard NIC Mezzanine Card
To remove the standard NIC mezzanine card:
1.
Power down the server blade and remove it from the server blade enclosure. Refer to the
“Server Blade Preparation” section in this chapter.
2.
Remove the access panel. Refer to the “Access Panel” section in this chapter.
3.
Remove the FC adapter. Refer to “HP ProLiant BL30p Dual Port Fibre Channel Adapter”
section in this chapter.
