HP ProCurve Series 2810, Management And Configuration Manual

Page: 309 / 420

File Transfers
Downloading Switch Software
CLI: Xmodem Download from a PC or Unix Workstation
to Primary or Secondary Flash
Using Xmodem and a terminal emulator, you can download a switch software
file to either primary or secondary flash.
Syntax
:
copy xmodem flash [< primary | secondary >]
Note that if you do not specify the flash destination, the Xmodem download
defaults to primary flash.
For example, to download a switch software file named G0103.swi from a PC
(running a terminal emulator program such as HyperTerminal) to primary
flash:
1. Execute the following command in the CLI:
Figure A-4. Example of the Command to Download Switch Software Using
Xmodem
2. Execute the terminal emulator commands to begin the Xmodem transfer.
For example, using HyperTerminal:
a. Click on
Transfer
, then
Send File
.
b. Type the file path and name in the Filename field.
c. In the Protocol field, select
Xmodem
.
d. Click on the Send button.
The download can take several minutes, depending on the baud rate used
in the transfer.
3. When the download finishes, you must reboot the switch to implement
the newly downloaded switch software. To do so, use one of the following
commands:
boot system flash <primary | secondary>
Reboots the switch from the selected flash memory.
-or­
reload
Reboots the switch from the flash image currently in use.
(For more on these commands, refer to “Rebooting the Switch” on page
6-17.)
A-13