HP ProCurve Series 2810, Management And Configuration Manual

Page: 195 / 420

Port Status and Basic Configuration
Jumbo Packets
traffic from devices on either VLAN. For a method to allow only some
ports in a VLAN to receive jumbo traffic, refer to “Operating Notes for
Jumbo Traffic-Handling” on page 10-20.
Configuring Jumbo Packet Operation
Command Page
show vlans 10-18
show vlans ports < port-list > 10-19
show vlans < vid > 10-20
jumbo 10-20
Overview
1. Determine the VLAN membership of the ports or trunks through which
you want the switch to accept inbound jumbo traffic. For operation with
GVRP enabled, refer to the GVRP topic under “Operating Rules”, above.
2. Ensure that the ports through which you want the switch to receive jumbo
packets are operating at least at gigabit speed. (Check the Mode field in
the output for the show interfaces brief < port-list > command.)
3. Use the jumbo command to enable jumbo packets on one or more VLANs
statically configured in the switch. (All ports belonging to a jumbo-
enabled VLAN can receive jumbo packets.
4. Execute write memory to save your configuration changes to the startup­
config file.
10-17