SROS Command Line Interface Reference Guide
Group Configuration Command Set
5991-2114
© Copyright 2007 Hewlett-Packard Development Company, L.P.
1427
G
ROUP
C
ONFIGURATION
C
OMMAND
S
ET
To activate the Terminal Access Controller Access Control System Plus () Group
Configuration mode, enter the
aaa group server
command at the Global Configuration mode
prompt. For example:
ProCurve>
enable
ProCurve#
configure terminal
ProCurve(config)#
aaa group server TEST GROUP
ProCurve(config-sg-)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
All other commands for this command set are described in this section in alphabetical order.