HP ProCurve 8116fl, Installation And Getting Started Manual

Page: 77 / 134

Replacing Hardware
Replacing Modules
■ Interface modules do not have redundant protection. If an interface
module fails, traffic on the module will stop until you can replace the
module.
Fail Over Protection
If the primary management module fails, the redundant management module
will reboot the switch fabric module and interface modules. During this time,
service is affected.
To perform a controlled shutdown on a management or fabric module and
cause the redundant module to take over, enter the following command:
Switch 8100fl(config)#halt <slot>
You can also perform a controlled shutdown on a module, by entering the
following command:
Switch 8100fl(config)#power down <slot>
N o t e
To display a list of the slot numbers of all installed modules, type
?
after the
command; for example,
halt ?
or
power down ?
.
4-5
R
e
pl
a
c
in
g H
a
rd
wa
re