HP ProCurve 8116fl, Installation And Getting Started Manual

Page: 64 / 134

Get
ting
S
ta
rte
d W
ith
S
w
it
ch
Co
nfi
gurati
o
n
Getting Started With Switch Configuration
Setting Basic System Information
Saving and Using the New Configuration
To apply the system commands entered in the previous steps to the startup
configuration, follow the steps below:
1. To display the running configuration, enter the following command:
Switch 8100fl(config)#show running
For example:
Switch 8100fl(config)#show running
!
interface Management0
no shutdown
ip address 10.10.1.45/21
!
ip telnet
no shutdown
!
line vty 0
!
line vty 1
!
line vty 2
!
end
2. To save the configuration changes from the running configuration to the
startup configuration file, enter the write memory command:
Switch 8100fl(config)#write memory
The switch reinstates all configuration changes for the next reboot.
Setting the System Date and Time
To set the system date and time:
1. From the Privileged Exec mode (#) prompt, enter the clock set command:
Switch 8100fl#clock set
<
HH:MM:SS
> <
1...31
> <
month
> <
year
>
2. To verify your settings, enter the
show clock
command:
Switch 8100fl#show clock
3-4