HP ProCurve 8116fl, Installation And Getting Started Manual

Page: 16 / 134

In
trodu
cin
g
the
ProCurve
Series 8100fl Switch
Introducing the ProCurve Series 8100fl Switch
Front of the Switch
Fan Trays
The chassis contains two fan tray assemblies to provide a cooling air flow
across the switch modules. Each fan tray assembly contains three fans. The
fan tray assembly is hot swappable to allow for easy replacement of fans.
LEDs
The tables in this section describe how the LEDs on the switch chassis and
modules show the operational status of the switch and network connections.
Management Module LEDs
The management module has Active and Status LEDs showing the module’s
operational status, plus LEDs on the RJ-45 port showing network connections.
The LED states are described in the following table.
Table 1-1. Management Module (J8731A) LEDs
Management Module LED Color State Meaning
PCMCIA Card
Slot
Active Green
Green
n/a
Flashing
Solid
Off
Negotiating active/backup management
module(s) during boot sequence.
Module is active - normal.
Module is in back up mode.
10/100 Base-T
Port (RJ-45)
Status n/a
Green
Green
Yellow/
Orange
Off
Flashing
Solid
Flashing
No power to the module.
Module is booting up and downloading
operating software.
Module is in service - normal.
Self-test failure.
10/100 Base-T Port
Active and
Status LEDs
Activity
(Act) n/a
Green
Off
Flashing
No data is being transferred and/or no
connector is plugged into the port.
Transmitting data.
Link n/a
Green
Off
Solid
No connector is plugged into the port.
Link is up.
1-6