HP ProCurve 8116fl, Installation And Getting Started Manual

Page: 108 / 134

Swi
tch
Po
rts a
nd Ne
two
rk
Cable
s
Switch Ports and Network Cables
Twisted-Pair Cable/Connector Pin-Outs
Straight-Through Twisted-Pair Cable for
10/100 Mbps Network Connections
The RJ 45 port on the management module operates as an MDI-X port, and
straight-through cables
must be used for connections to the management
console. The same connections and pin-outs shown here for the management
module can also be used on the 10-Port 100/1000 Base-T interface module for
100 Mbps network connections only.
Cable Diagram
Management Module Management Console
RJ45 Connector RJ45 Connector
N o t e
Pins 1 and 2 on the management module connector
must
be wired as a twisted
pair to pins 1 and 2 on the management console connector.
Pins 3 and 6 on the management module connector
must
be wired as a twisted
pair to pins 3 and 6 on the management console connector.
Pins 4, 5, 7, and 8 are not used in this application, although they may be wired
in the cable.
.
Pin Assignments
Management Module End (MDI-X) Management Console, or
Other End
Signal Pins Pins Signal
tr 1 1 r
transmit - 2 2 receive ­
r 3 3 tr
receive - 6 6 transmit ­
B-6