Command Line Interface (CLI)
upload
Uploads a text-based configuration file from the AP to the TFTP Server. Executing
upload
with the asterisk character
(“*”) will make use of the previously set/stored TFTP parameters. Executing
upload
without parameters will display
command help and usage information.
1.
Syntax to upload a file:
[Device-Name]>
upload <tftp server address> <path and filename> <filetype>
Example:
[Device-Name]>
upload 192.168.1.100 APconfig.sys config
2.
Syntax to display help and usage information:
[Device-Name]>
help upload
3.
Syntax to execute the upload command using previously set (stored) TFTP Parameters:
[Device-Name]>
upload *
Parameter Control Commands
The following sections cover the two Parameter Control Commands (
show
and
set
) and include several tables
showing parameter properties. These commands allow you to view (
show
) all parameters and statistics and to change
(
set
) parameters.
•
show:
To see any Parameter or Statistic value, you can specify a single parameter, a Group, or a Table.
•
set:
Use this CLI Command to change parameter values. You can use a single CLI statement to modify Tables, or
you can modify each parameter separately.
“show” CLI Command
Displays the value of the specified parameter, or displays all parameter values of a specified group (parameter table).
Groups contain Parameters and Tables. Tables contain parameters for a series of similar entities.
To see a definition and syntax example, type only
show
and then press the
Enter
key. To see a list of available
parameters, enter a question mark (
?
) after
show
(example:
show ?
).
Syntax:
[Device-Name]>
show <parameter>
[Device-Name]>
show <group>
[Device-Name]>
show <table>
Examples:
[Device-Name]>
show ipaddr
[Device-Name]>
show network
[Device-Name]>
show mgmtipaccesstbl
“set” CLI Command
Sets (modifies) the value of the specified parameter. To see a definition and syntax example, type only
set
and then
press the
Enter
key. To see a list of available parameters, enter a space, then a question mark (
?
) after
set
(example:
set?
).
Syntax:
[Device-Name]>
set <parameter> <value>
[Device-Name]>
set <table> <index> <argument 1> <value 1> ... <argument N> <value N>
Example:
[Device-Name]>
set sysloc “Main Lobby”
[Device-Name]>
set mgmtipaccesstbl 0 ipaddr 10.0.0.10 ipmask 255.255.0.0
C-8
