HP PROCURVE 2910AL, Access Security Manual

Page: 515 / 594

Configuring Port-Based and User-Based Access Control (802.1X)
Messages Related to 802.1X Operation
Messages Related to 802.1X Operation
Table 12-6. 802.1X Operating Messages
Message Meaning
Port
< port-list >
is not an authenticator.
The ports in the port list have not been enabled as 802.1X
authenticators. Use this command to enable the ports as
authenticators:
ProCurve(config)# aaa port-access
authenticator e 10
Port
< port-list >
is not a supplicant.
Occurs when there is an attempt to change the supplicant
configuration on a port that is not currently enabled as a
supplicant. Enable the port as a supplicant and then make
the desired supplicant configuration changes. Refer to
“Enabling a Switch Port as a Supplicant” on page 12-51.
No server(s) responding.
This message can appear if you configured the switch for
EAP-RADIUS or CHAP-RADIUS authentication, but the
switch does not receive a response from a RADIUS server.
Ensure that the switch is configured to access at least one
RADIUS server. (Use
show radius .) If you also see the
message
Can’t reach RADIUS server <
x.x.x.x >
, try the suggestions listed for that message
(page 5-50).
LACP has been disabled on 802.1X port(s).
To maintain security, LACP is not allowed on ports
configured for 802.1X authenticator operation. If you
configure port security on a port on which LACP (active or
passive) is configured, the switch removes the LACP
configuration, displays a notice that LACP is disabled on the
port(s), and enables 802.1X on that port.
Error configuring port
< port-number >
:
Also, the switch will not allow you to configure LACP on a
LACP and 802.1X cannot be run together. port on which port access (802.1X) is enabled.
12-75