HP ProCurve 2810-24G, Management And Configuration Manual

Page: 74 / 272

3-16
GVRP
Introduction
Figure 3-10. Example of Listing Showing Dynamic VLANs
Converting a Dynamic VLAN to a Static VLAN. If a port on the switch
has joined a dynamic VLAN, you can use the following command to convert
that dynamic VLAN to a static VLAN:
Syntax : static < dynamic - vlan-id >
For example, to convert dynamic VLAN 333 (from the previous example) to a
static VLAN:
ProCurve(config)# static 333
When you convert a dynamic VLAN to a static VLAN, all ports on the switch
are assigned to the VLAN in Auto mode.
Web: Viewing and Configuring GVRP
To view, enable, disable, or reconfigure GVRP:
1. Click on the
Configuration
tab.
2. Click on
VLAN Configuration
and do the following:
a. To enable or disable GVRP, click on GVRP Enabled .
b. To change the Unknown VLAN field for any port:
i.
Click on
GVRP Security
and make the desired changes.
ii. Click on
Apply
to save and implement your changes to the
Unknown VLAN fields.
For web-based Help on how to use the web browser interface screen, click on
the
[?]
button provided on the web browser screen.
Dynamic VLANs
Learned from
Switch “A”
through Port 1