HP ProCurve 2810-24G, Management And Configuration Manual

Page: 123 / 272

5-23
Multiple Instance Spanning-Tree Operation
802.1s Multiple Spanning Tree Protocol (MSTP)
Configuring Per Port Parameters
spanning-tree priority page
5-25
root-guard
tcn-guard
loop-protect
Syntax: [no] spanning-tree <port-list> admin-edge-port
Enable admin-edge-port on ports connected to end nodes.
During spanning tree establishment, ports with
admin-
edge-port enabled transition immediately to the
forwarding state. If a bridge or switch is detected on the
segment, the port automatically operates as
non-edge
, not
enabled. (Default: No - disabled )
If
admin-edge-port
is disabled on a port and
auto-edge-port
has not been disabled, the
auto-edge-port
setting controls
the behavior of the port.
The no spanning-tree < port-list > admin-edge-port
command
disables edge-port operation on the specified ports.
Syntax: [no] spanning-tree < port-list > auto-edge-port
Supports the automatic identification of edge ports. The
port will look for BPDUs for 3 seconds; if there are none it
begins forwarding packets. If
admin-edge-port
is enabled
for a port, the setting for auto-edge-port is ignored whether
set to yes or no. If
admin-edge-port
is set to
No
, and
auto-
edge-port
has not been disabled (set to
No
), then the
auto-
edge-port
setting controls the behavior of the port. (Default:
Yes - enabled
)
The
no spanning-tree < port-list > auto-edge-port
command
disables
auto-edge-port
operation on the specified ports.
Command Page