HP OmniBook 800, Evaluator Manual

Page: 119 / 149

Features and Support Services
Standard Features
8-3
Standard Features
Processor Intel Pentium 166-MHz processor with MMX technology .
Cache 32K L1 cache .
512K pipelined burst-synchronous L2 cache.
Architecture 32-bit PCI (Peripheral Component Interconnect) bus architecture .
Mass storage Industry-standard, 2.5 inch 2.1GB removable Enhanced-IDE hard drive:
•
ATA2 Interface.
•
Partial Response Maximum Likelihood recording method and Magneto
Resistive heads.
Memory 16 MB RAM Standard on Motherboard.
1 memory slot can handle 16MB, 32MB or 64MB HP proprietary memory card.
Expandable up to 80MB.
Cycle Type: 60ns.
Memory Type: EDO (Extended Data Output) RAM is a significantly faster RAM
that utilizes pipelining operation, getting the next requested data ready while
the first data is being handed off.
Flexible Disk Drive External Ultra-Thin 3.5-inch floppy disk drive.
Automatic detection of external floppy drive on most operating systems without
rebooting.
Dedicated floppy drive port on the back of the OmniBook.
PC Card Slots Texas Instruments TI1131 PC Card Controller Chip.
2 Type II or 1 Type III User-available, Industry-compatible PC card slots.
Intel QuickSwap Bus (ExCa).
Support for PC CardBus and Zoomed Video.
Built-in I/O Serial port: 9-pin, 115,000-bps RS-232 (16550 UART).
Parallel port: 25-pin bi-directional ECP and EPP.
VGA-out port.
4 Mbps IrDA-2 port.
Stereo-in, stereo-out, microphone-in ports.
AC adapter.
External floppy.
OmniBook 800 Docking System Connector/SCSI-2 Port (requires cable F1182A).