263
Step Command
Remarks
4.
Configure a filter policy to
filter outgoing routes.
filter-policy
{
acl6-number
|
ipv6-prefix
ipv6-prefix-name
}
export
[
protocol
[
process-id
] ]
By default, RIPng does not filter
outgoing routing information.
Configuring a priority for RIPng
Any routing protocol has its own protocol priority used for optimal route selection. You can set a priority
for RIPng manually. The smaller the value, the higher the priority.
To configure a RIPng priority:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIPng view.
ripng
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
3.
Configure a RIPng priority.
preference
[
route-policy
route-policy-name
]
preference
Optional.
By default, the RIPng priority is
100.
Configuring RIPng route redistribution
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIPng view.
ripng
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
3.
Configure a default routing
metric for redistributed routes.
default cost
cost
Optional.
The default metric of redistributed
routes is 0.
4.
Redistribute routes from
another routing protocol.
import-route
protocol
[
process-id
]
[
allow-ibgp
] [
cost
cost
|
route-policy
route-policy-name
] *
By default, no route redistribution
is configured.
Tuning and optimizing the RIPng network
This section describes how to tune and optimize the performance of the RIPng network, as well as
applications under special network environments. Before tuning and optimizing the RIPng network,
complete the following tasks:
•
Configure a network layer address for each interface.
•
Configure the basic RIPng functions.
