HP MSR SERIES, Configuration Manual, Page: 245 / 889

228
Configuring a rule for a basic IPv4 ACL
Select Advanced > QoS Setup > ACL IPv4 from the navigation tree and then select the Basic Config tab
to enter the rule configuration page for a basic IPv4 ACL.
Figure 235 The page for configuring an basic IPv4 ACL
Table 112 Configuration items
Item Description
ACL
Select the basic IPv4 ACL for which you want to configure rules.
ACLs available for selection are basic IPv4 ACLs.
Rule ID
Select the Rule ID box, and enter a number for the rule.
If you do not specify the rule number, the system will assign one automatically.
If the rule number you specify already exists, the following operations modify the
configuration of the rule.
Action
Select the action to be taken on the IPv4 packets matching the rule:
•
Permit —Allows matched packets to pass.
•
Deny —Drops matched packets.
Check Fragment
Select this box to apply the rule only to non-first fragments.
If you do not select this box, the rule applies to all fragments and non-fragments.