429
Step Command
Remarks
3.
Enter IPv6 address family
view.
ipv6-family
N/A
4.
Enable BGP route refresh for a
peer or a peer group.
peer
{
group-name
|
ipv6-address
}
capability-advertise
route-refresh
Optional.
Enabled by default.
If this feature is not enabled, you
must configure this command.
5.
Enable the non-standard ORF
capability for a BGP peer or a
peer group.
peer
{
group-name
|
ipv6-address
}
capability-advertise
orf non-standard
Optional.
By default, standard BGP ORF
capability defined in RFC 5291
and RFC 5292 is supported.
If this feature is not enabled, you
must configure this command.
6.
Enter IPv6 MBGP address
family view.
ipv6-family multicast
N/A
7.
Enable the ORF IP prefix
negotiation capability for a
BGP peer or a peer group
peer
{
group-name
|
ipv6-address
}
capability-advertise
orf ip-prefix
{
both
|
receive
|
send
}
Not enabled by default.
Table 34
Description of the send, receive, and both parameters and the negotiation result
Local parameter
Peer parameter
Negotiation result
send
•
receive
•
both
The ORF sending capability is enabled locally and
the ORF receiving capability is enabled on the
peer.
receive
•
send
•
both
The ORF receiving capability is enabled locally and
the ORF sending capability is enabled on the peer.
both both
Both the ORF sending and receiving capabilities
are enabled locally and on the peer.
Configuring the maximum number of equal-cost routes for
load-balancing
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP view.
bgp
as-number
N/A
3.
Enter IPv6 MBGP address
family view.
ipv6-family multicast
N/A
4.
Configure the maximum
number of equal-cost routes
for load balancing.
balance
number
By default, load balancing is
disabled.