Removal and replacement procedures 29
2.
Install the chassis into the J-slot on the rails, and then pull it forward.
3.
Push in the release lever, and then install the chassis into the rack.
CAUTION:
Press and hold the "Push" tab on each rail until the chassis begins to slide into the
rack. Then, release the "Push" tabs and continue to slide the chassis into the rack. Press and hold
the "Push" tab on each rail again when the rails lock at a 76.2-cm (30-inch) extension. Then,
release the "Push" tabs again and finish sliding the chassis into the rack. Failure to release the
"Push" tabs may cause damage to the rails.
Power up the chassis
If the chassis was powered off while installing the cartridge, then power up the chassis. The cartridges are
hot-pluggable and do not require that you power down the chassis for installation.
1.
Connect the power cables to the power supplies.
2.
Connect the power cables to the power source (UPS or wall outlet) or to an installed PDU.
Summary of Contents for Moonshot 1500
Page 12: ...Customer self repair 12 ...
Page 13: ...Customer self repair 13 ...
Page 14: ...Customer self repair 14 ...