Front-panel error codes
Under certain circumstances, a numeric error code appears on the front panel. Follow the advice in the
Recommendation column to resolve the error. If the recommendation does not seem to solve the problem, call your
service representative.
If an error code appears on the front panel that is not included in this list, turn o
ff
the cutter and then turn it back on.
If the problem persists, call your service representative.
Error code
Recommendation
7.1 X-axis error! Over
fl
ow
or Overcurrent!
Cause: The drum motor cannot move to the required position.
Action:
1.
Remove the crashed substrate and restart the machine.
2.
Lower the substrate speed.
3.
Check whether the drive drum turns smoothly (
fi
rst turn the power o
ff
and
place the cam rollers in the up-position).
4.
If problems continue, call your HP representative.
7.2 Y-axis error! Over
fl
ow
or Overcurrent!
Cause: The motor driving the machine head cannot move to the required position.
Action:
1.
Remove the crashed substrate and restart the machine.
2.
Lower the speed and/or the knife pressure.
3.
Check whether the head moves smoothly (
fi
rst turn the power o
ff
and position
the cam rollers on the outer edges of the substrate).
4.
If problems continue, call your HP representative.
7.3 OPOS sensing errors
Cause: OPOS does not sense markers, or senses values with which it cannot work.
Action:
1.
Check the OPOS parameters and compare them to the printout. Set correct
parameters.
2.
Check whether there is dust on the sensor tip.
3.
Set substrate calibration OPOS to default and run the OPOS test found on the
manual CD.
4.
Check the connection cable which runs from the head to the PCB.
5.
Check the machine with another head (OPOS).
6.
Check re
fl
ection values with OPOS monitor.
7.
Check the
fl
at cable going from the head to the PCB.
8.
If problems continue, call your HP representative.
ENWW
5
Eng
lish
