HP Integrity rx5670, Hardware Installation Manual

Page: 23 / 46

Chapter 2
Installing Additional Components
Installing Processors and Memory
23
Installing Processors and Memory
This section provides information about installing processors and memory. Processors and memory are
located under the Top Cover.
WARNING Ensure that the system is powered-down and all power sources have been
disconnected from the server prior to attempting the following procedures.
Voltages are present at various locations within the server whenever an AC power
source is connected. This voltage is present even when the main power switch is in
the off position.
Failure to observe this warning could result in personal injury or damage to
equipment.
CAUTION
Do not operate the server without the Top Cover in place. Operation of the server without the
Top Cover in place will result in server failure. Operation of the server without the Top Cover
in place will make the server susceptible to EMI problems.
Observe all ESD safety precautions before attempting this procedure. Failure to follow ESD
safety precautions could result in damage to the server.
Removing the Top Cover
To remove the Top Cover, perform the following steps:
1. Loosen the captive T-15 screws that hold the Top Cover in place.