HP Indigo Press WS4000, Service Manual

Page: 7 / 221

HP Indigo press ws4000 Cluster 1 procedures
proprietary and confidential CA293-00600, Rev 00 page 7 of 221
Figure 134 ESB board with old connector on J38 ......................................................122
Figure 135 Ceiling cover gasket.................................................................................123
Figure 136 Removing the right Molex from the GDB panel........................................123
Figure 137 CC108C cables pulled from ESB board on back of press .......................124
Figure 138 Output assembly front cover ....................................................................125
Figure 139 Laser shroud tube assembly seen from Output of press .........................125
Figure 140 Roof top panel and left channel cover removed.......................................126
Figure 141 Running the CC108C cable from the ESB board to the left channel .......127
Figure 142 MPT-4099-51 Light guard assembly ........................................................128
Figure 143 ILD cooling assembly P/N 245-00840......................................................129
Figure 144 ILD cooling fan and CC108C connectors.................................................129
Figure 145 Scorotrons and scorotron bridge..............................................................130
Figure 146 Removing the scorotrons .........................................................................131
Figure 147 Scorotron Bridge control handle...............................................................131
Figure 148 Removing the screw from the back of the pivot shaft ..............................132
Figure 149 Removing the C clips from the pivot shaft................................................132
Figure 150 Removing the pivot arms .........................................................................133
Figure 151 Removing screw from front side of pivot shaft .........................................133
Figure 152 Spacers between the drive motor and the plate.......................................135
Figure 153 Washer screw and anaerobic adhesive ...................................................135
Figure 154 Reconnecting encoder and power connectors.........................................136
Figure 155 Push interlock cable Molex connector through the wall ...........................137
Figure 156 Connect the interlock Molex.....................................................................137
Figure 157 Secure the interlock and pneumatic piston ..............................................138
Figure 158 Replacing the interlock cable cover .........................................................139
Figure 159 Pneumatic manifold..................................................................................139
Figure 160 Connecting the manifold connector..........................................................140
Figure 161 Connecting the main air supply to the manifold .......................................141
Figure 162 Engage NIP roller air hoses .....................................................................142
Figure 163 Attaching the ground cables.....................................................................142
Figure 164 Vacuum box supporters ...........................................................................144
Figure 165 Installed vacuum box supporters .............................................................144
Figure 166 Vacuum box ground cables......................................................................145
Figure 167 Installing Input and Output side vacuum box brackets.............................147
Figure 168 Vacuum box hoses with clamps alternated..............................................148
Figure 169 Cables from touchscreen to junction box and Profibus............................149
Figure 170 Motor plate position..................................................................................151
Figure 171 Installing motor on Output assembly wall.................................................152
Figure 172 Removing the preheater connector bracket cover ...................................153
Figure 173 Removing the preheater spindle screws ..................................................153
Figure 174 Removing the reheater spindle and spring ..............................................154