HP Indigo press ws4000 Cluster 1 procedures
proprietary and confidential
CA293-00600, Rev 00
page 175 of 221
Figure 210 Inspection plate and antistatic brush installed
•4. Install long brush on the lower Exit roller.
Figure 211 Long brush brass rod and clamps
a. Install the long brush on the brass rod if it is not already installed.
b. Unscrew and remove the two screws on each antistatic clamp (See
Note:
The brush clamps are interchangeable. This enables them to be used for any of
the antistatic brushes anywhere in the press. As a result they can be set to two
possible positions. Ensure when you install the brushes that the clamps lock in
place so the brushes brush against the paper.
