509
Step
Command
Remarks
21.
Set a backup link for fast
reroute (FRR).
•
Set an IPv4 backup link
for FRR:
apply
fast-reroute
{
backup-interface
interface-type
interface-number
[
backup-nexthop
ip-address
] |
backup-nexthop
ip-address
}
•
Set an IPv6 backup link
for FRR:
apply
ipv6
fast-reroute
{
backup-interface
interface-type
interface-number
[
backup-nexthop
ipv6-address
] |
backup-nexthop
ipv6-address
}
By default, no backup link is set for
FRR.
Configuring the continue clause
Follow these guidelines when you configure the
continue
clause to combine multiple nodes:
•
If you configure an
apply
clause that sets different attribute values on all the nodes, the
apply
clause of the node configured most recently takes effect.
•
If you configure the following
apply
clauses on all the nodes, the
apply
clause of each node
takes effect:
apply as-path
without the
replace
keyword.
apply cost
with the
+
or
–
keyword.
apply community
with the
additive
keyword.
apply extcommunity
with the
additive
keyword.
•
The
apply comm-list delete
clause configured on the current node cannot delete the
community attributes set by the
apply community
clauses of the preceding nodes.
To configure the
continue
clause:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter routing policy node
view.
route-policy
route-policy-name
{
deny
|
permit
}
node
node-number
N/A
3.
Specify the next node to be
matched.
continue
[
node-number
]
By default, no continue clause is
configured.
The specified next node must
have a larger number than the
current node.
Displaying and maintaining the routing policy
Execute
display
commands in any view and
reset
commands in user view.
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
