409
Step
Command
Remarks
2.
Enter interface view.
interface
interface-type interface-number
N/A
3.
Advertise a summary IPv6
prefix.
ripng summary-address ipv6-address
prefix-length
By default, the
summary IPv6 prefix
is not configured.
Advertising a default route
You can configure RIPng to advertise a default route with the specified cost to its neighbors.
To configure RIPng to advertise a default route:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter interface view.
interface
interface-type
interface-number
N/A
3.
Configure RIPng to advertise
a default route.
ripng default-route
{
only
|
originate
} [
cost
cost-value
|
route-policy
route-policy-name
] *
By default, RIPng does not advertise a
default route.
This command advertises a default
route on the current interface
regardless of whether the default
route exists in the local IPv6 routing
table.
Configuring received/redistributed route filtering
Perform this task to filter received or redistributed routes by using an IPv6 ACL or IPv6 prefix list. You
can also configure RIPng to filter routes redistributed from other routing protocols and routes from a
specified neighbor.
To configure a RIPng route filtering policy:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RIPng view.
ripng
[
process-id
] [
vpn-instance
vpn-instance-name
]
N/A
3.
Configure a filter policy
to filter received routes.
filter-policy
{
ipv6-acl-number
|
prefix-list
prefix-list-name
}
import
By default, RIPng does not filter
received routes.
4.
Configure a filter policy
to filter redistributed
routes.
filter-policy
{
ipv6-acl-number
|
prefix-list
prefix-list-name
}
export
[
protocol
[
process-id
] ]
By default, RIPng does not filter
redistributed routes.
Setting a preference for RIPng
Routing protocols each have a preference. When they find routes to the same destination, the route
found by the routing protocol with the highest preference is selected as the optimal route. You can
manually set a preference for RIPng. The smaller the value, the higher the preference.
To set a preference for RIPng:
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
