298
Step
Command
Remarks
2.
Enter BGP IPv6 unicast
address family view, or BGP
IPv6 multicast address family
view.
•
Enter BGP IPv6 unicast
address family view:
a. bgp
as-number
[
instance
instance-name
]
b. address-family ipv6
[
unicast
]
•
Enter BGP IPv6 multicast
address family view:
c. bgp
as-number
[
instance
instance-name
]
d. address-family ipv6
multicast
N/A
3.
Configure the router as a
route reflector and specify a
peer or peer group as its
client.
peer
{
group-name
|
ipv6-address
[
prefix-length
] }
reflect-client
By default, no route reflector or
client is configured.
4.
Enable route reflection
between clients.
reflect between-clients
By default, route reflection
between clients is enabled.
5.
(Optional.) Configure the
cluster ID of the route
reflector.
reflector cluster-id
{
cluster-id
|
ipv4-address
}
By default, a route reflector uses
its own router ID as the cluster ID.
Ignoring the ORIGINATOR_ID attribute
By default, BGP drops incoming route updates whose ORIGINATOR_ID attribute is the same as the
local router ID. Some special networks require BGP to accept such route updates. To meet the
requirement, you must configure BGP to ignore the ORIGINATOR_ID attribute.
To ignore the ORIGINATOR_ID attribute (IPv4 unicast/multicast address family):
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter BGP instance view or
BGP-VPN instance view.
•
Enter BGP instance view:
bgp
as-number
[
instance
instance-name
]
•
Enter BGP-VPN instance
view:
a. bgp
as-number
[
instance
instance-name
]
b. ip vpn-instance
vpn-instance-name
N/A
3.
Ignore the ORIGINATOR_ID
attribute.
peer
{
group-name
|
ipv4-address
[
mask-length
] }
ignore-originatorid
By default, BGP does not ignore
the ORIGINATOR_ID attribute.
Make sure this command does not
result in a routing loop.
After you execute this command,
BGP also ignores the
CLUSTER_LIST attribute.
To ignore the ORIGINATOR_ID attribute (IPv6 unicast/multicast address family):
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
