14
Configuring static route FRR to automatically select a backup
next hop
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure static route FRR to
automatically select a
backup next hop.
ip route-static fast-reroute auto
By default, static route FRR is
disabled from automatically
selecting a backup next hop.
Enabling BFD echo packet mode for static route FRR
By default, static route FRR uses ARP to detect primary link failures. Perform this task to enable
static route FRR to use BFD echo packet mode for fast failure detection on the primary link.
To enable BFD echo packet mode for static route FRR:
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Configure the source IP
address of BFD echo
packets.
bfd echo-source-ip ip-address
By default, the source IP address
of BFD echo packets is not
configured.
The source IP address cannot be
on the same network segment as
any local interface's IP address.
For more information about this
command, see
High Availability
Command Reference
.
3.
Enable BFD echo packet
mode for static route FRR.
ip route-static
primary-path-detect bfd echo
By default, BFD echo mode for
static route FRR is disabled.
Displaying and maintaining static routes
Execute
display
commands in any view.
Task
Command
Display static route information.
display ip routing-table
protocol
static
[
inactive
|
verbose
]
Display static route next hop
information.
display route-static nib
[
nib-id
] [
verbose
]
Display static routing table
information.
display route-static routing-table
[
vpn-instance
vpn-instance-name
] [
ip-address
{
mask-length
|
mask
} ]
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
