133
Process ID: 1
SubProtID: 0x1 Age: 04h20m37s
Cost: 1 Preference: 10
IpPre: N/A QosLocalID: N/A
Tag: 0 State: Active Adv
OrigTblID: 0x0 OrigVrf: default-vrf
TableID: 0x2 OrigAs: 0
NibID: 0x26000002 LastAs: 0
AttrID: 0xffffffff Neighbor: 0.0.0.0
Flags: 0x1008c OrigNextHop: 13.13.13.1
Label: NULL RealNextHop: 13.13.13.1
BkLabel: NULL BkNextHop: 24.24.24.2
Tunnel ID: Invalid Interface: Vlan-interface200
BkTunnel ID: Invalid BkInterface: Vlan-interface101
FtnIndex: 0x0 TrafficIndex: N/A
Connector: N/A
Troubleshooting OSPF configuration
No OSPF neighbor relationship established
Symptom
No OSPF neighbor relationship can be established.
Analysis
If the physical link and lower layer protocols work correctly, verify OSPF parameters configured on
interfaces. Two neighbors must have the same parameters, such as the area ID, network segment,
and mask. (A P2P or virtual link can have different network segments and masks.)
Solution
To resolve the problem:
1.
Use the
display ospf peer
command to verify OSPF neighbor information.
2.
Use the
display ospf interface
command to verify OSPF interface information.
3.
Ping the neighbor router's IP address to verify that the connectivity is normal.
4.
Verify OSPF timers. The dead interval on an interface must be a minimum of four times the
hello interval.
5.
On an NBMA network, use the
peer ip-address
command to manually specify the neighbor.
6.
A minimum of one interface must have a router priority higher than 0 on an NBMA or a
broadcast network.
7.
If the problem persists, contact Hewlett Packard Enterprise Support.
Incorrect routing information
Symptom
OSPF cannot find routes to other areas.
Summary of Contents for HPE FlexNetwork 7500 series
Page 505: ...493 Connector N A ...
