Option B: Non-DHCP Environment
To set the IP address of the VSP:
1.
In the VMware vSphere Client window, select the
Console
tab, click anywhere on the screen,
and press
Enter
.
2.
Log on as
setupusr
. Press
Enter
.
A password is not required to configure the network settings.
3.
Enter the SP IP address and press
Enter
.
4.
Enter the Netmask address and press
Enter
.
5.
Enter the default gateway address and press
Enter
.
6.
Enter
Y
to configure the network and press
Enter
.
7.
Review the configuration confirmation and record the VSP IP address for reference during
subsequent setup procedures with 3PAR SmartStart or the 3PAR Service Processor Setup
Wizard.
8.
Press
Enter
to exit.
9.
Press
Ctrl-Alt
to release the cursor.
10. Continue on to
“Service Processor and System Setup” (page 98)
to set up the VSP with
3PAR SmartStart over the public network. If you are not using 3PAR SmartStart, see
“Installing HPE 3PAR Storage Software When HPE 3PAR SmartStart is Unavailable” (page
127)
.
NOTE:
This network configuration is temporary. If the VSP is rebooted, you will need to
repeat this procedure before continuing to the SP configuration.
Importing the HPE 3PAR VSP into Hyper-V
This section describes the prerequisites and procedures for importing the VSP into Hyper-V.
WARNING!
Do not install the VSP on the same 3PAR StoreServ 8000 Storage system that
the VSP manages, because it might lead to the inability of properly managing the array when
connectivity to the storage is unavailable.
Provision the VSP on a Hyper-V server and ensure that the VSP boots from the local disk of the
assigned Hyper-V server, not from the 3PAR StoreServ 8000 Storage LUNs.
System Requirements
•
Host operating system requirements:
NOTE:
Hyper-V is supported only on x86-64 versions of Windows Server.
◦
Microsoft Windows Server 2012 R2 (Standard or Datacenter Edition)
◦
Microsoft Windows Server 2008 R2 (Standard, Enterprise, or Datacenter Edition)
◦
Microsoft Windows Server 2012 (Standard or Datacenter Edition)
•
Processor requirements:
x86-64 processor version
◦
◦
Hardware-assisted virtualization support
NOTE:
This support is available in processors that include a virtualization option,
such as Intel VT or AMD Virtualization (AMD-V).
Importing the HPE 3PAR VSP into Hyper-V
93
Summary of Contents for HPE 3PAR StoreServ 8000
Page 142: ...142 Warranty and regulatory information ...
Page 143: ...Regulatory Information 143 ...
