HP G62 Series, Maintenance And Service Manual

Page: 102 / 135

System Configuration menu
NOTE: Some of the listed System Configuration options might not be supported by the computer.
Select To do this
Language Change the Computer Setup language.
Boot options ● Set an f9 , f10 , and f12 delay when starting up.
●
Enable/disable CD-ROM boot.
● Enable/disable floppy boot.
●
Enable/disable internal network adapter boot.
● Enable/disable MultiBoot, which sets a boot order that
can include most boot devices in the system.
●
Set the Express Boot Popup delay in seconds.
● Set the boot order.
◦
1st boot device—USB CD-ROM
◦ 2nd boot device—USB floppy
◦
3rd boot device—USB SuperDisk
◦ 4th boot device—Notebook hard drive
◦
5th boot device—USB hard disk
◦ 6th boot device—Network controller
Device Configurations
●
Swap the functions of the fn key and left ctrl key.
● Enable/disable USB legacy support. When enabled,
USB legacy support allows the following:
◦
Use of a USB keyboard in Computer Setup even
when the operating system is not running.
◦ Startup from bootable USB devices, including a
hard drive, diskette drive, or optical drive
connected by a USB port to the computer.
●
Enable/disable BIOS DMA data transfers.
● Enable/disable fan always on while connected to an AC
outlet.
●
Enable/disable data execution prevention.
● Enable/disable LAN power saving mode.
●
Enable/disable SATA Native Mode.
● Enable/disable Dual Core CPU.
●
Enable/disable HDD translation mode.
92 Chapter 5 Setup Utility