HP FlexNetwork NJ5000, User Manual

Page: 63 / 475

51
Item Description
the box below.
•
kbps
—
Sets the maximum number of kilobits of unicast traffic that can be
forwarded on an Ethernet port per second. When you select this option, you must
enter a number in the box below.
Selected Ports
Interface or interfaces that you have selected from the chassis front panel and the
aggregate interface list below, for which you have set operation parameters.
You can set only the state and MAC learning limit for an aggregate interface.
If you set operation parameters that a port does not support, you are notified of invalid settings and
might fail to set the supported operation parameters for the port or other ports.
Displaying port operation parameters
Displaying a specified operation parameter for all ports
1.
Select
Device
>
Port Management
from the navigation tree.
The
Summary
page appears by default.
2.
Select the option for a parameter you want to view.
The parameter information for all the ports is displayed in the lower part of the page.
Figure 42 The Summary tab
Displaying all the operation parameters for a port
1.
Select
Device
>
Port Management
from the navigation tree
2.
Click the
Detail
tab.
3.
Select a port whose operation parameters you want to view in the chassis front panel.
The operation parameter settings of the selected port are displayed on the lower part of the
page. Whether the parameter takes effect is displayed in the square brackets.