HP FlexNetwork NJ5000, User Manual

Page: 241 / 475

229
4.
Click
Apply
.
Table 89 Configuration items
Item Description
Destination IP Address Enter the destination host or network IP address in dotted decimal notation.
Mask
Enter the mask of the destination IP address.
You can enter a mask length or a mask in dotted decimal notation.
Preference
Set a preference value for the static route. This setting is for route selection
among multiple routes to the same destination.
You can use the default setting because you can have only one IPv4 static route
to one destination.
Next Hop Enter the next hop IP address in dotted decimal notation.
Interface Select the management VLAN interface as the outgoing interface.
NOTE:
To remove a route, access the
Remove
tab.
Displaying the IPv4 active route table
Select
Network
>
IPv4 Routing
from the navigation tree. The
Summary
tab displays the IPv4
routing table.
The IPv4 routing table contains direct routes that are automatically generated by the system as well
as an IPv4 static route if you have configured one.
Figure 235 IPv4 active route table
Creating an IPv6 static route
1.
Select
Network
>
IPv6 Routing
from the navigation tree.
2.
Click the
Create
tab.