113
1.
From the navigation tree, select
Network
>
VLAN
.
2.
Click
Modify Port
.
3.
Select the port that you want to configure on the chassis front panel.
4.
Select the
Link Type
option.
5.
Set the link type to access, hybrid, or trunk.
6.
Click
Apply
.
A progress dialog box appears.
7.
Click
Close
on the progress dialog box when the dialog box prompts that the configuration
succeeds.
Figure 118 Modifying ports
Setting the PVID for a port
You can also configure the PVID of a port on the
Setup
tab of
Device
>
Port Management
. For more
information, see "
To set the PVID for a port:
1.
From the navigation tree, select
Network
>
VLAN
.
2.
Click
Modify Port
.
3.
Select the port that you want to configure on the chassis front panel.
4.
Select the
PVID
option.
The option allows you to modify the PVID of the port.
5.
Set a PVID for the port. By selecting the
Delete
box, you can restore the PVID of the port to the
default, which is VLAN 1.
The PVID of an access port must be an existing VLAN.
6.
Click
Apply
.
A progress dialog box appears.
7.
Click
Close
on the progress dialog box when the dialog box prompts that the configuration
succeeds.
Summary of Contents for FlexNetwork NJ5000
