266
Step Command
Remarks
2.
Configure a static
route for a VPN
instance.
•
Method
1:
ip
route-static
dest-address
{
mask
|
mask-length
} {
gateway-address
|
interface-type
interface-number
[
gateway-address
] |
vpn-instance
d-vpn-instance-name
gateway-address
}
[
preference
preference-value
] [
tag
tag-value
] [
description
description-text
]
•
Method
2:
ip route-static
vpn-instance
s-vpn-instance-name
&<1-5>
dest-address
{
mask
|
mask-length
}
{
gateway-address
[
public
] |
interface-type
interface-number
[
gateway-address
] |
vpn-instance
d-vpn-instance-name
gateway-address
}
[
preference
preference-value
] [
tag
tag-value
] [
description
description-text
]
Use either command as
needed.
Perform this configuration on
PEs. On CEs, configure
normal static routes.
For more information about
static routing, see
Layer
3—IP Routing Configuration
Guide
.
Configuring RIP between a PE and a CE
A RIP process belongs to the public network or a single VPN instance. If you create a RIP process
without binding it to a VPN instance, the process belongs to the public network.
To configure RIP between a PE and a CE:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create a RIP process for a
VPN instance and enter RIP
view.
rip
[
process-id
]
vpn-instance
vpn-instance-name
Perform this configuration on
PEs. On CEs, create a normal
RIP process.
3.
Enable RIP on the interface
attached to the specified
network.
network
network-address
By default, RIP is disabled on an
interface.
For more information about RIP, see
Layer 3
—
IP Routing Configuration Guide
.
Configuring OSPF between a PE and a CE
An OSPF process that is bound to a VPN instance does not use the public network router ID
configured in system view. Therefore, you must specify the router ID when starting a process or to
configure the IP address for at least one interface of the VPN instance.
An OSPF process belongs to the public network or a single VPN instance. If you create an OSPF
process without binding it to a VPN instance, the process belongs to the public network.
To configure OSPF between a PE and a CE:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Create an OSPF process for
a VPN instance and enter
the OSPF view.
ospf
[
process-id
|
router-id
router-id
|
vpn-instance
vpn-instance-name
] *
Perform the configurations on
PEs. On CEs, create a normal
OSPF process.