30
Use
mdix-mode
to configure the Medium Dependent Interface Cross-Over (MDIX) mode of an
Ethernet interface.
Use
undo mdix-mode
to restore the default.
Syntax
mdix-mode
{
automdix
|
mdi
|
mdix
}
undo mdix-mode
Default
Ethernet interfaces operate in
automdix
mode.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
automdix
: Specifies that the interface negotiates pin roles with its peer.
mdi
: Specifies that pins 1 and 2 are transmit pins and pins 3 and 6 are receive pins.
mdix
: Specifies that pins 1 and 2 are receive pins and pins 3 and 6 are transmit pins.
Examples
# Set GigabitEthernet 1/0/1 to operate in MDI mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] mdix-mode mdi
multicast-suppression
Use
multicast-suppression
to enable multicast storm suppression and set the multicast storm
suppression threshold.
Use
undo multicast-suppression
to restore the default.
Syntax
multicast-suppression
{
ratio
|
pps max-pps
|
kbps max-kbps
}
undo
multicast-suppression
Default
Ethernet interfaces do not suppress multicast traffic.
Views
Layer 2 Ethernet interface view
Predefined user roles
network-admin
Parameters
ratio
: Sets the multicast suppression threshold as a percentage of the maximum interface rate. The
value range for this argument (in percentage) is 0 to 100. The smaller the percentage, the less
multicast traffic is allowed to pass through.
pps max-pps
: Specifies the maximum number of multicast packets that the interface can forward per
second. The value range for the
max-pps
argument (in pps) is 0 to 1.4881 × the maximum interface
Summary of Contents for FlexNetwork 5130 HI series
Page 302: ...294 ...
