151
undo stp tc-protection threshold
Default
By default, the device can perform a maximum of six forwarding address entry flushes every 10
seconds.
Views
System view
Predefined user roles
network-admin
Parameters
number
: Sets the maximum number of immediate forwarding address entry flushes that the device
can perform every 10 seconds. The value is in the range of 1 to 255.
Examples
# Configure the device to perform up to 10 forwarding address entry flushes every 10 seconds.
<Sysname> system-view
[Sysname] stp tc-protection threshold 10
Related commands
stp tc-protection
stp tc-restriction
Use
stp tc-restriction
to enable TC-BPDU transmission restriction.
Use
undo stp tc-restriction
to disable TC-BPDU transmission restriction.
Syntax
stp tc-restriction
undo stp tc-restriction
Default
TC-BPDU transmission restriction is disabled.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
Usage guidelines
When TC-BPDU transmission restriction is enabled on a port, the port does not send TC-BPDUs to
the other ports. It also does not delete the MAC address entries.
When the setting is configured in Layer 2 Ethernet interface view, it takes effect only on that
interface.
When the setting is configured in Layer 2 aggregate interface view, it takes effect only on the
aggregate interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after
the port leaves the aggregation group.
Examples
# Enable TC-BPDU transmission restriction on GigabitEthernet 1/0/1.
Summary of Contents for FlexNetwork 5130 HI series
Page 302: ...294 ...
