45
Default
The terminal display type is ANSI.
Views
User line view, user line class view
Predefined user roles
network-admin
mdc-admin
Parameters
ansi
:
Specifies the terminal display type ANSI.
vt100
: Specifies the terminal display type VT100.
Usage guidelines
The device supports two terminal display types: ANSI and VT100. As a best practice, set the display
type to VT100 on both the device and the configuration terminal. If either side uses the ANSI type, a
display problem such as cursor positioning error might occur when a command line has more than
80 characters.
Examples
# Set the terminal display type to VT100.
<Sysname> system-view
[Sysname] line vty 0
[Sysname-line-vty0] terminal type vt100
user-interface
Use
user-interface
to enter one or multiple user line views.
Syntax
user-interface
{
first-number1
[
last-number1
] | {
aux
|
vty
}
first-number2
[
last-number2
] }
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
first-number1
: Specifies the absolute number of the first user line. The value range is 0 to 65 in
standalone mode and 0 to 71 in IRF mode.
last-number1
: Specifies the absolute number of the last user line. This number cannot be smaller
than
first-number1
.
aux
: Specifies the AUX line.
vty
: Specifies the VTY line.
first-number2
: Specifies the relative number of the first user line. The value ranges are as follows:
•
AUX line
—0 to 1 in standalone mode and 0 to 7 in IRF mode.
•
VTY line
—0 to 63.
