26
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RADIUS scheme
view.
radius scheme
radius-scheme-name
N/A
3.
Set the format for
usernames sent to the
RADIUS servers.
user-name-format
{
keep-original
|
with-domain
|
without-domain
}
The default setting depends on the type of
the startup configuration:
•
If the device starts up with initial
settings, the ISP domain name is
included in a username.
•
If the device starts up with the default
configuration file, the ISP domain name
is included in a username except for the
predefined RADIUS scheme named
system
. When the username is sent to a
RADIUS server in the
system
scheme,
the ISP domain name is removed.
For more information about the startup
configuration, see
Fundamentals
Configuration Guide
.
4.
(Optional.) Set the data
flow and packet
measurement units for
traffic statistics.
data-flow-format
{
data
{
byte
|
giga-byte
|
kilo-byte
|
mega-byte
}
|
packet
{
giga-packet
|
kilo-packet
|
mega-packet
|
one-packet
} }*
By default, traffic is counted in bytes and
packets.
Setting the maximum number of RADIUS request transmission attempts
RADIUS uses UDP packets to transfer data. Because UDP communication is not reliable, RADIUS uses a
retransmission mechanism to improve reliability. A RADIUS request is retransmitted if the NAS does not
receive a server response for the request within the response timeout timer. For more information about
the RADIUS server response timeout timer, see "
."
You can set the maximum number for the NAS to retransmit a RADIUS request to the same server. When
the maximum number is reached, the NAS tries to communicate with other RADIUS servers in active state.
If no other servers are in active state at the time, the NAS considers the authentication or accounting
attempt a failure.
To set the maximum number of RADIUS request transmission attempts:
Step Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter RADIUS scheme view.
radius scheme
radius-scheme-name
N/A
3.
Set the maximum number of RADIUS
request transmission attempts.
retry
retry-times
The default setting is 3.
Setting the status of RADIUS servers
To control the RADIUS servers with which the device communicates when the current servers are no
longer available, set the status of RADIUS servers to blocked or active. You can specify one primary
