Locating internal components
Components
(1)
Hard drive
(3)
RTC battery
(2)
M.2 SSD (under the fan)
(4)
Memory modules
Removing and installing memory
The memory slots on the system board can be populated with up to two industry-standard small outline dual
inline memory modules (SODIMMs). These memory slots are populated with at least one preinstalled memory
module.
Memory module specifications
For proper system operation, the memory modules must meet the following qualifications:
Component
Specification
Memory modules
1.2 volt DDR4-SDRAM memory modules
Compliance
Unbuffered non-ECC DDR4-2400 MHZ–compliant
Pins
Industry-standard 260 pins containing the mandatory Joint Electronic Device
Engineering Council (JEDEC) specification
Support
Support CAS latency DDR4 2400 MHz (15–15–15 timing)
Slots
2
Maximum Memory
16 GB per memory slot, 32 GB total
Supported
4 Gbit and 8 Gbit non-ECC memory technologies single-sided and double-sided SODIMMs
Note
The system will not operate properly if you install unsupported SODIMM
memory. SODIMMs constructed with x8 and x16 DDR devices are supported; memory
modules constructed with x4 SDRAM are not supported.
HP offers upgrade memory for this computer and advises that the consumer purchase it to avoid
compatibility issues with unsupported third-party memory.
Locating internal components
21