Power supply
For a list of available power supplies, see
Computer major components on page 5
.
The power supply is secured to the rear of the chassis with three screws. Three cables connect the power
supply to the system board.
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 19
2.
Remove the access panel (
).
3.
Remove the drive cage (
4.
Remove the three Torx T15 screws that connect the power supply to the rear of the chassis.
5.
From the inside of the chassis, remove the power supply cables from the clips built into the bottom of
the chassis.
6.
Disconnect the power supply cables from the following system board connector:
●
PWRCMD
64
Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
Summary of Contents for EliteDesk 800 G3
Page 4: ...iv Safety warning notice ...
Page 9: ...Appendix D Specifications 151 TWR Specifications 151 Index 153 ix ...
Page 10: ...x ...
Page 39: ...Drive cage 29 ...