Hood lock (solenoid)
The hood lock is secured to the rear of the chassis with two screws.
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 19
2.
Remove the access panel (
).
3.
From the rear of the chassis, remove the two security screws that secure the hood lock.
4.
From the inside of the chassis, disconnect the cable from the system board connector labeled HLCK (1).
5.
Remove the hood lock from the inside of the computer (2).
To install the hood lock, reverse the removal procedure.
62
Chapter 4 Removal and replacement procedures – Microtower (MT) chassis
Summary of Contents for EliteDesk 800 G3
Page 4: ...iv Safety warning notice ...
Page 9: ...Appendix D Specifications 151 TWR Specifications 151 Index 153 ix ...
Page 10: ...x ...
Page 39: ...Drive cage 29 ...