Installing a 5.25-inch drive
1.
Prepare the computer for disassembly (
Preparation for disassembly on page 19
)
2.
Remove the access panel (
3.
Remove the front bezel (
). If you are installing a drive in a bay covered by a bezel
blank, remove the bezel blank. See
Removing bezel blanks on page 23
for more information.
4.
If you are installing an optical drive, install four M3 metric mounting screws (not provided) in the lower
holes on each side of the drive.
NOTE:
When replacing an optical drive, transfer the four M3 metric mounting screws from the old drive
to the new one.
IMPORTANT:
Use only 5 mm long screws as mounting screws. Longer screws can damage the internal
components of the drive.
Drives
39
Summary of Contents for EliteDesk 800 G3
Page 4: ...iv Safety warning notice ...
Page 9: ...Appendix D Specifications 151 TWR Specifications 151 Index 153 ix ...
Page 10: ...x ...
Page 39: ...Drive cage 29 ...