Solid-state drive (SSD)
Description
Spare part number
512 GB, PCIe, Gen3×4, SS/DS, NVMe, MLC
914935-001
512 GB, PCIe, Gen3×4, SS, NVMe, TLC, Opal 2
914934-001
512 GB, PCIe, NVMe, Gen3x4, MLC
914933-001
512 GB, SATA-3, FIPS-140–2, TLC
917382-003
360 GB, PCIe Gen3×4 SS TLC
919691-003
256 GB, PCIe, Gen3x4, NVMe, TLC
914931-001
256 GB, SATA-3, Opal 2, TLC
914930-001
128 GB, SATA-3, SS, TLC
914929-001
Before removing the solid-state drive, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the bottom cover (see
).
5.
Disconnect the battery (see
).
Remove the solid-state drive:
1.
Remove the Phillips M2.0×3.0 screw (1) that secures the drive to the system board.
2.
Remove the drive (2) by pulling it away from the connector.
NOTE:
M.2 solid-state drives are designed with notches to prevent incorrect insertion.
Reverse this procedure to install the solid–state drive.
Component replacement procedures
39
