Remove and replace the right PCIe riser card
Procedure
1.
on page 23).
2.
on page 23).
3.
Remove the access panel (
Removing the PCIe access panel
on page 23).
4.
Remove the right PCIe riser assembly (
Removing the right PCIe riser assembly
on page 27).
5.
Using a Torx screwdriver, remove the three T-15 Torx screws, and then remove the PCIe riser card.
To replace the component, reverse the removal procedure.
Removing and replacing the PCIe QSFP+ riser card
About this task
The QSFP+ riser card is supported only on the HPE Edgeline EL4000 PassThru System.
Procedure
1.
on page 23).
2.
on page 23).
3.
Remove the access panel (
Removing the PCIe access panel
on page 23).
4.
Remove the left PCIe riser assembly (
Removing the left PCIe riser assembly
on page 26).
5.
Remove the right PCIe riser assembly (
Removing the right PCIe riser assembly
on page 27).
6.
Disconnect the QSFP+ riser card cable from the baseboard.
7.
Using a Torx screwdriver, remove the two T-15 screws and remove the QSFP+ riser card.
Remove and replace the right PCIe riser card
39
Summary of Contents for Edgeline EL4000
Page 18: ...18 Customer self repair ...
Page 19: ...Customer self repair 19 ...
Page 20: ...20 Customer self repair ...
Page 65: ...wireless wide area network Acronyms and abbreviations 65 ...
