HP E4510-48G, Command Reference Manual

Page: 89 / 1334

1-35
Default Level
2: System level
Parameters
seconds : Interval for generating traffic statistics, in the range 1 to 300 (in seconds).
Description
Use the storm-constrain interval command to set the interval for generating traffic statistics.
Use the undo storm-constrain interval command to restore the default.
By default, the interval for generating traffic statistics is 10 seconds.
z
The interval set by the storm-constrain interval command is specifically for the storm constrain
function. It is different form that set by the flow-interval command.
z
For network stability consideration, configure the interval for generating traffic statistics to a value
that is not shorter than the default.
Examples
# Set the interval for generating traffic statistics to 60 seconds.
<Sysname> system-view
[Sysname] storm-constrain interval 60
unicast-suppression
Syntax
unicast-suppression { ratio | pps max-pps }
undo unicast-suppression
View
Ethernet port view, port group view
Default Level
2: System level
Parameters
ratio : Maximum percentage of unicast traffic to the total transmission capability of an Ethernet port, in
the range of 1 to 100. The smaller the ratio is, the less unicast traffic is allowed through the interface.
pps max-pps : Specifies the maximum number of unknown unicast packets passing through an
Ethernet port per second (in pps, representing packets per second).
z
For a Gigabit port, the value range is 1 to 1488100;
z
For a 10-Gigabit port, the value range is 1 to 14881000.