HP E4510-48G, Command Reference Manual

Page: 82 / 1334

1-28
interface-number : Number of a specified interface.
Description
Use the reset packet-drop interface command to clear statistics of dropped packets on an interface
or multiple interfaces. Sometimes when you want to collect the statistics of dropped packets on an
interface, you need to clear the old statistics on the interface first.
z
If you do not specify an interface type or interface number, this command clears statistics of
dropped packets on all the interfaces on the device.
z
If you specify an interface type only, this command clears statistics of dropped packets on the
specified type of interfaces.
z
If you specify both the interface type and interface number, this command clears statistics of
dropped packets on the specified interface.
Examples
# Clear statistics of dropped packets on GigabitEthernet 1/0/1.
<Sysname> reset packet-drop interface GigabitEthernet 1/0/1
# Clear statistics of dropped packets on all interfaces.
<Sysname> reset packet-drop interface
shutdown
Syntax
shutdown
undo shutdown
View
Ethernet port view
Default Level
2: System level
Parameters
None
Description
Use the shutdown command to shut down an Ethernet port.
Use the undo shutdown command to bring up an Ethernet port.
By default, an Ethernet port is in the up state.
In certain circumstances, modification to the interface parameters does not immediately take effect,
and therefore, you need to shut down the relative interface to make the modification work.
Note that in case of a Combo port, only one interface (either the optical port or the electrical port) is
active at a time. That is, once the optical port is active (after you execute the undo shutdown
command), the electrical port will be inactive automatically, and vice versa.