HP E4510-48G, Command Reference Manual

Page: 393 / 1334

12-37
z
If the first method is used, the neighbor entry is in the INCMP state. After the device obtains the
corresponding Layer 2 port information through resolution, the neighbor entry will go into the
REACH state.
z
If the second method is used, the corresponding VLAN interface must exist and the port specified
by port-type port-number must belong to the VLAN specified by vlan-id . After the static neighbor
entry is configured, the device will relate the VLAN interface with the IPv6 address to identify the
static neighbor entry uniquely and the entry will be in the REACH state.
To remove a static neighbor entry, you only need to specify the corresponding VLAN interface and the
neighbor address.
Related commands: display ipv6 neighbors .
Examples
# Configure a static neighbor entry for Layer 2 port GigabitEthernet1/0/1 of VLAN 100.
<Sysname> system-view
[Sysname] ipv6 neighbor 2000::1 fe-e0-89 100 gigabitethernet 1/0/1
ipv6 neighbors max-learning-num
Syntax
ipv6 neighbors max-learning-num number
undo ipv6 neighbors max-learning-num
View
Interface view
Default Level
2: System level
Parameters
number : Maximum number of neighbors that can be dynamically learned by the interface, in the range
1 to 128.
Description
Use the ipv6 neighbors max-learning-num command to configure the maximum number of
neighbors that can be dynamically learned on the interface.
Use the undo ipv6 neighbors max-learning-num command to restore the default.
By default, the maximum number of neighbors that can be dynamically learned on the interface is 128.
Examples
# Set the maximum number of neighbors that can be dynamically learned on VLAN-interface 100 to
10.
<Sysname> system-view
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] ipv6 neighbors max-learning-num 10