HP E4510-48G, Command Reference Manual

Page: 292 / 1334

5-6
This command applies to configuring the non-user-defined remote ID sub-option only. After you
configure the padding content for the remote ID sub-option using the dhcp relay information
remote-id string command, ASCII is adopted as the code type.
Examples
# Configure the code type for the non-user-defined remote ID sub-option as ascii .
<Sysname> system-view
[Sysname] interface vlan-interface 1
[Sysname-Vlan-interface1] dhcp relay information remote-id format-type ascii
dhcp relay information remote-id string
Syntax
dhcp relay information remote-id string { remote-id | sysname }
undo dhcp relay information remote-id string
View
Interface view
Default Level
2: System level
Parameters
remote-id : Padding content for the user-defined remote ID sub-option, a case sensitive string of 1 to 63
characters.
sysname : Specifies the device name as the padding content for the remote ID sub-option.
Description
Use the dhcp relay information remote-id string command to configure the padding content for the
user-defined remote ID sub-option.
Use the undo dhcp relay information remote-id string command to restore the default.
By default, the padding content for the remote ID sub-option depends on the padding format of Option
82.
Note that: After you configure the padding content for the remote ID sub-option using this command,
ASCII is adopted as the code type.
Related commands: dhcp relay information format .
If you want to specify the character string sysname (a case-insensitive character string) as the
padding content for the remote ID sub-option, you need to use quotation marks to make it take effect.
For example, if you want to specify Sysname as the padding content for the remote ID sub-option, you
need to enter the dhcp relay information remote-id string “Sysname” command.